Samson AR1 Specifications download pdf (Page 11)

1: A/B Receiver LEDs - When signal is being received, one of these will be lit

orange, showing you whether the (left) “A” or (right) “B” receiver is currently being

used. The UM1 constantly scans its two antennas and automatically selects

whichever is receiving the strongest, clearest signal. This True Diversity switching

is completely inaudible, but it effectively increases overall range while virtually

eliminating potential interference and phase cancellation problems.

2: Meter - This set of three multicolor LEDs acts as a meter, indicating either bat-

tery power or the strength of the incoming RF signal. This meter can also be dis-

abled altogether to conserve battery power. See #15 on page 11 for more

information.

3: Peak LED - This LED lights red when output signal from the UM1 is at the onset

of clipping (that is, when it is on the verge of being distorted). If you see this light

during operation, move the microphone further away or lower the output level of

your instrument or transmitter. For more information, see the section entitled

“Setting Up and Using the AirLine System” on page 17 in this manual.

4: Power switch - Use this to turn the UM1 power on and off.

5: SQ (Squelch) Level control - This control determines the maximum range of the

UM1 before audio signal dropout. Although it can be adjusted using the supplied

plastic screwdriver, it should normally be left at its factory setting. See the “Setting

Up and Using the AirLine System” section on page 17 in this manual for more

information.

Samson AirLine

Guided Tour - UM1 Receiver

SAMSON

MAX

MIN

POWER

SQ LEVEL

UHF MICRO DIVERSITY RECEIVER

LOW MID HIGH PEAK

800MHz

2 3 1

ENGLISH

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 89 90

No comments

Samson AR1 Specifications Page 11