Samson UM1 Specifications download pdf (Page 9)

Guided Tour - UH1

1: Audio on-off switch - When set to the “on”

position, audio signal is transmitted. When set to

the “off” position, the audio signal is muted.

Because the carrier signal remains during muting,

no “pop” or “thud” will be heard. Note that turning

this off does

not turn off the transmitter power—it is

simply a way to temporarily mute the transmission

of audio signal. If you don’t plan on using the

transmitter for extended periods, turn off the

transmitter power by using the power on-off switch

(see #3 below).

2: Battery level meter - This set of three

multicolor LEDs indicates relative battery power,

indicating whether the installed battery is at low

(red), mid (yellow) or high (green) strength.

One of these will light whenever the UH1 is

powered on (see #3 below). When the red “low”

indicator lights, RF performance is degraded and

the battery needs to be replaced.

3: Power on-off switch* - Use this to turn the

UH1 on or off (to conserve battery power, be sure

to leave it off when not in use).

4: Microphone Input Level control (trimpot) -

This input sensitivity control has been factory

preset to provide optimum level for the particular microphone capsule provided with your

UM1 system and so we recommend that this not be adjusted manually. If necessary,

however, you can use the supplied plastic screwdriver to raise or lower the input level.

See the “Setting Up and Using the UM1 System” section on page 8 in this manual for

more information.

5: Battery holder - Insert a standard 9-volt alkaline battery here, being sure to observe

the plus and minus polarity markings shown. We recommend the Duracell MN 1604 type

battery. Although rechargeable Ni-Cad batteries can be used, they do not supply

adequate current for more than four hours.

WARNING: Do not insert the battery

backwards; doing so can cause severe damage to the UH1 and will void your warranty.

* Be sure to mute the audio signal at your external mixer or amplifier before turning

transmitter power on or off, or an audible pop may result.

SAMSON

MIN

MAX

LEVEL

POWER

OFF

AUDIO

OFF ON

LOW

MID

HIGH

BATT

ENGLISH

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 44 45

Comments to this Manuals

No comments

Samson UM1 Specifications Page 9

Comments to this Manuals

Related products and manuals for Microphones Samson UM1