Samson VR88 Owner's Manual download pdf (Page 13)

VR88 Active Velocity Ribbon Microphone

Using the Shockmount

Follow the steps below for mounting the VR88 to a mic

stand you can use the included “Spider” shockmount.

• First, screw the shockmount onto your mic stand or

boom arm. If you’re using a US 5/8” mic stand or

boom, remove the Euro adapter.

• Install the VR88 into the shockmount by fitting the

microphone into the center of the holder, positioning

the VR88 all the way to the bottom mounting plate.

• Secure the shockmount by tightening the threaded

collar, rotating clockwise until tight.

• Now, loosen the thumb screw to adjust the angle

of the microphone and position the VR88 to the

desired location. Once set, tighten the thumbscrew

to secure the microphone in place.

Note: Be careful not to cross thread or over tighten

the threaded collar or thumb screw.

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Samson VR88 Owner's Manual Page 13