Samson TM300 Specifications download pdf (Page 11)

Guided Tour - Rear Panel

1: Vent - To ensure proper cooling of the TM300 power amplifier, make sure this vent is

unobstructed at all times.

2: Fuse holder - Holds an 8 A / 250 V fuse for 115 volt operation or a 4 A / 250 V fuse

for 230 volt operation

3: AC input - Connect the supplied heavy gauge 3-pin “IEC” power cable here.

4: Speaker Outputs - These are the TM300’s main outputs; use these four unbalanced

jacks (two of which carry the left signal and two of which carry the right) to connect the

TM300 to loudspeakers rated at 4 ohms or greater (that is, 4, 8, or 16 ohms). The

lower the ohm rating, the greater the power output. We recommend the use of 4 ohm

speakers for long-term usage. The TM300 delivers 150 watts of power per channel into

4 ohms at less than 1% THD (Total Harmonic Distortion). In order to ensure correct

phase correlation, the tip of the TM300 speaker jack should be connected to the “+” (hot)

input of your loudspeaker, and the sleeve of the TM300 speaker jack should be

connected to the “-” (ground) input of your loudspeaker. Note that, when the Aux 1 /

Monitor switch (see # 19 on page 8) is pressed in, the TM300 operates in a “split mono”

configuration, where the left speaker output carries the main stereo output (internally

mixed to mono) and the right speaker output carries Aux send 1.

5: Power on-off switch - As you may have guessed, this is what you use to turn the

TM300 on and off. If the TM300 is connected to external power amps (via its Main Insert

and/or Mono output jacks—see #4 and #5 on page 6 in this manual), turn it on

before

you turn on the connected amps—and turn it off after the connected amps are turned off.

6: Fan - This variable-speed fan provides vital cooling to your TM300 power amp

(the hotter the amp gets, the faster the fan blows!). Make sure that cool, fresh air is

accessible at all times. Also, try to ensure that the TM300 is used in a dust-free

environment.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS;

RISQUE DE CHOC ELECTRIQUE

NE PAS OUVRIR

DO NOT EXPOSE THIS EQUIPMENT

TO RAIN OR MOISTURE.

SAMSON

TM300 6 CHANNEL 150WATT STEREO MIXER

SPEAKER

OUT

CAUTION:

DO NOT BLOCK AIRFLOW

OFF

POWER

USE CLASS 2 WIRING

MINIMUM LOAD

IMPEDANCE 4

SERIAL NUMBER

CAUTION: TO REDUCE THE

RISK OF FIRE, REPLACE ONLY

WITH SAME TYPE FUSE.

AC INPUT

115V/230V,50/60Hz

780W

FUSE

8A/250V(115V)

4A/250V(230V)

Ω

ENGLISH

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 57 58

Comments to this Manuals

No comments

Samson TM300 Specifications Page 11

Comments to this Manuals

Related products and manuals for Mixers Samson TM300