Samson S Class Specifications download pdf (Page 12)

If you’re operating your PA system Mono 3-way, wire your system as shown in the system diagram below.

Once you have your system wired-up, follow the steps below:

• Locate the MODE switch in the master section and set it to the MONO 3 W position.

• Notice the outlined boxes showing the frequencies that are now under control by the associated GAIN or

FREQUENCY knobs.

• Now, use the first crossover FREQ on Channel 1 to set the desired

frequency dividing the low and mid frequencies.

• Next, set the frequency point dividing the mid and high by using

Channel 2’s crossover FREQ control.

• Now, adjust the first gain control on Channel 1 to set the level of the

LOW frequency output.

• Next, adjust the second gain control on Channel 1 to set the level of

the MID frequency output.

• Next, adjust the second gain control on Channel 2 to set the level of

the HIGH frequency output.

• You can use an RTA (Real Time Analyzer), or an even more sophisticated piece of test gear, your ears,

to adjust the balance between the low, (mid) and high end. You can continue to raise the Gain controls

as you fine-tune the system. Watch the Peak Meters on your power amplifiers to ensure that you’re run-

ning a clean signal.

S 2-way System Set-Ups

MONO THREE WAY OPERATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Samson S Class Specifications Page 12