AR300 Operation
Setting a Group and Channel Manually
The AR300 receiver contains 320 selectable channels for N and U band, and 71
selectable channels for E band. All channels are organized into a series of groups.
Each group contains channels that are compatible for simultaneous use. When using
multiple systems, each system should be assigned to the same group in order to
maximize the number of compatible channels. Each group is designated with a letter,
followed by the group channel number (0–9) which is displayed under the “GROUP”
icon in the AR300 LCD display.
To the right of the Group and Group Channel number is the read out Absolute channel
number. This three-digit Absolute Channel number corresponds to the exact channel
from the entire channel plan. That Absolute Channel number is shown on the AG300
transmitter’s LCD display.
The AG300 displays the Absolute Channel number it its LCD for a few seconds, and
then the display shuts off to preserve battery power. You can also see the transmitters
Absolute Channel number by switching the Mute on. In addition, the AG300 will also
display the Absolute Channel number briefly when the power is shut off.
1. Press the EDIT control once and you will see the Group and Group Channel Number
Flash.
2. Turn the EDIT controller and you will see the Group and Group Channel number
change, and you will also see the Absolute Channel number change in sync.
3. If you prefer, you can choose the Absolute Channel. Simply press the EDIT control
again until the Absolute Channel number flashes. Then, turn the EDIT controller
and you will see the Absolute Channel number change. It changes in sync with the
Group Channel number.
4. Once you have the desired channel set on the AR300 you’re ready to transmit the
infrared channel data to the AG300. Have the transmitter ready in your hand with
the Power switch set to off.
5. Double click the EDIT controller and you see the display flash “IR SET” indicating that
the AR300 is sending the channel information over infrared transmission.
6. Now, position the transmitter about 6-inches from the front of the AR300 with the
AG300 IR receiver facing the AR300’s LCD display and turn the power switch on.
You will now see the corresponding Absolute Channel in the AG300 LCD display
indicating that the transmitter is matched to the receiver.
12
(18 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals