Samson Power Amplifiers Owner's Manual download pdf (Page 10)

Front Callouts

1 2 3 5 2

1. Power Switch - Use this switch to power the MXS amplifier on or off

2. Channel Level Controls - Two detent controls to precisely adjust and the match the

output level of each channel

3. MODE Indicators - The corresponding indicator lights based off of the setting of the

rear panel MODE switch (Stereo, Bridge, Parallel).

4. FILTER Indicators - These LED indicators light depending on the setting of the rear

panel FILTER switch (Full, 28Hz, 120Hz).

5. Audio Indicators - The front panel LED indicators monitor the power output level for

the corresponding channel:

PEAK: The PEAK indicator lights whenever the channel is outputting signal

at full strength. For the best signal-to-noise ratio, the right (PEAK)

segment should light occasionally during peak levels; if it lights

frequently, you may be overloading the amplifier and a distorted

(“clipped”) signal is probably being output. If this occurs and backing

off the Input Level control delivers too low an output level for your

application.

-10: Lights whenever the output level reaches -10dB below the distortion or

clipping

SIGNAL: These LED indicators continuously monitor the input level for the

corresponding channel. The SIGNAL LED lights whenever signal is

present.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Samson Power Amplifiers Owner's Manual Page 10