Samson 120A Specifications download pdf (Page 13)

Connecting the RESOLV 120a

 







OUTPUT

CHANNEL 1

CHANNEL 2

MINIMUM LOAD IMPEDANCE

STEREO

(4/CHANNEL)

BRIDGED MONO

(8)

















CAUTION

; REPLACE WITH THE SAME TYPE FUSE AS INDICATED.

UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.

ww w. sam son tec h.c om

CHANNEL 1

TIP RING SLEEVE

TIP +

RING -

SLEEVE GND

CHANNEL

TIP RING SLEEVE

TIP +

RING -

SLEEVE GND

INPUTS

BRIDGED

STEREO

MODE SELECTOR

(10K / 0dBu)

INPUT

(10K / 0dBu)

INPUT

20A / 250V

PUSH TO RESET

~AC INPUT

115V / 60Hz, 800W

SERIAL NUMBER

MADE IN KOREA













Mono Sub With Passive Satellites Using Speaker Inputs

The RESOLV 120a is a perfect addition to any near-field monitoring system where enhanced low-end is desired. Below is a

typical system set-up using the RESOLV 120a with a mixer, amplifier and a pair of passive satellite speakers. In this mode,

the signal sent to the satellite is high-passed at 100Hz. The RESOLV 120a’s inputs and outputs utilize industry standard

speaker connectors. Follow the steps in the diagram below to set up your system.

• Lower your mixer’s master outputs to all the way off.

• Connect the mixer’s left output to the left input of your power amp and the mixer’s right output to the right input of

your power amp. Now, using standard speaker cable, connect the power amp’s left speaker output to the RESOLV

120a’s LEFT SPEAKER INPUT and the power amp’s right speaker output to the RESOLV 120a’s RIGHT SPEAKER INPUT.

To complete the connections, run a cable from the RESOLV 120a’s LEFT SPEAKER OUTPUT to the left satellite and

from the RIGHT SPEAKER OUTPUT to the right satellite speaker.

• Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owner’s manual for a recom

mended crossover point. You can also use your ears by adjusting the SWEEP control to the frequency that sounds

good to you. A good place to start is about 70 Hz.

• Now set the level of your power amp up to the normal operating level. Run an audio signal (like some music from

a CD) through your mixer and raise the level to a comfortable listening level. Now slowly raise the RESOLV 120a

Volume control and listen to the low frequency output. Adjust the RESOLV 120a to the level of low frequency output

that you like. Now, when you raise and lower your mixer’s output, the RESOLV 120a and satellites will track at the

same relative volume.

ENGLISH

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 79 80

Comments to this Manuals

No comments

Samson 120A Specifications Page 13

Comments to this Manuals

Related products and manuals for Audio amplifiers Samson 120A