Samson AirLine Specifications download pdf (Page 4)

If you’ve had some prior experience using wireless systems, these QuickStart instructions will get you up and running with your

AirLine UHF guitar system in a matter of minutes! Detailed instructions for setting up and using your AirLine system can be found on

page 15 of this manual, and the “Guided Tour” sections on pages 4 - 14 provide full descriptions of all AirLine component controls

and displays.

1. Make sure that the supplied AP1 receiver and AF1 or AG1 transmitter are factory preset to the same channel.

2. Physically place the AP1 receiver on the ground in front of you. Extend its antennas vertically and spread the tips horizontally out-

wards approximately 5 inches.

3. Set the power switch on your AF1 or AG1 transmitter to the “off” position (away from the arrow) and place a fresh AAA battery in it.

Then turn the transmitter back on momentarily; its LED will flash once and then go off if the battery is sufficiently strong. Once

battery strength is verified, turn the transmitter off again, then plug it into your electric guitar or bass.

4. Open the battery compartment of the AP1 by pressing on the latch and install a fresh battery; if you prefer, you can use an optional

power supply instead. Turn the AP1 on momentarily to confirm that the battery has been installed correctly (or that the adapter has

been connected correctly); the “On/Battery Low” LED should light green and not red. Then turn the AP1 power off.

5. Turn your amplifier or mixer off and make the physical cable connection between an audio input and the AP1 output jack.

6. Turn the Level knob on the AP1 completely counterclockwise, then turn its power on; the “Power” LED will light steadily green.

7. Turn on your AF1 or AG1 transmitter. The “TX/Peak” LED on the AP1 receiver should light steadily green, indicating that it is

receiving valid RF signal and is placed and positioned correctly.

QuickStart

ENGLISH

Samson AirLine

1 2 3 4 5 6 7 8 9 ... 24 25

No comments

Samson AirLine Specifications Page 4