Samson AX300 Specifications Page 1

WIRELESS MICROPHONE SYSTEM

1. Antennas (A and B) - The antenna mountings allow full rotation for optimum placement. In normal operation, both Antenna A (the antenna on the le

6: EDIT Control – This rotary encoder control knob is used to control and set several menu functions and parameters displayed in the LCD display an

A: Antenna socket - D hole knockout for mounting the antennas to the rear panel using the optional rear antenna kit.B: DC input - Connect the su

1: Plug - Insert this standard 3-pin XLR plug into your the included Samson Q7 or any dynamic microphone. 2: LCD Display – This three digit Liq

8: Battery compartment - Insert a standard AA alkaline battery here, being sure to observe the plus and minus polarity markings shown. We recommend

The basic procedure for setting up and using your AirLine Synth system takes only a few minutes:1. Remove all packing materials (save them in case

6. Make the physical cable connection between the AR300 output jack and an audio input of your mixer. Leave your mixer and power amplifier off at t

12. Temporarily turn down the level of your mixer or amplifier and turn off the power to your transmitter, leaving the AR300 receiver on. Then resto

AR300/AX300 OperationSetting a Group and Channel Manually The AR300 receiver contains 320 selectable channels for N and U band, and 71 selectable chan

AR300/AX300 OperationOperating In FREE ModeYou can tune in an exact frequency using the AR300’s FREE mode. Once you are in FREE mode you can change th

WARNINGTO PREVENT FIRE OR SHOCK HAZARD. DO NOT USE THIS PLUG WITH AN EXTENON CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED

SYSTEM SPECIFICATIONS Channels 320 channels 25kHz Step (N and U Bands) 71 channels 25kHz Step (E Band)Operating Frequency 639.025–647 MHz 798

SpecificationsTRANSMITTER (AX300) Oscillation Type Crystal-controlled PLL frequency systhesizedModulation Type FMAntenna 1/4 Wave Length Dipole T

FCC Rules and RegulationsSamson wireless systems are type accepted under FCC rules parts 90, 74 and 15.Licensing of Samson equipment is the user’s re

We, Samson Technologies Corporation, located at 45 Gilpin Ave, Hauppauge, NY 11788 USA declare under our own responsibility that the Products:are in c

Samson Technologies Corp.45 Gilpin AvenueHauppauge, New York 11788-8816Phone: 1-800-3-SAMSON (1-800-372-6766)Fax: 631-784-2201 www.samsontech.com

ATTENTION: Pour éviter tout risque d’électrocution ou d’incendie, ne pas exposer cet appareil à la pluie ou à l’humidité. Pour éviter tout risque d’él

PRECAUCION: Para reducir el riesgo de incendios o descargas, no permita que este aparato quede expuesto a la lluvia o la humedad. Para reducir el ries

Copyright 2008-2009, Samson Technologies Corp.v2.1Samson Technologies Corp.45 Gilpin AvenueHauppauge, New York 11788-8816Phone: 1-800-3-SAMSON (1-800-

Table of ContentsContentsIntroduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7QuickStart . . . . . . . . . . . . . . . . . . . . . .

7IntroductionWelcome to Samson AirLine Synth—the next generation of wireless systems! Wireless microphone and instrument systems were originally devel

If you’ve had some prior experience using wireless systems, these QuickStart instructions will get you up and running with your AirLine UHF microphone

QuickStart7. Now to set the channel, press and hold the EDIT control until the display shows the group number with three asterisks. Next, the AR300