Samson VHF TD Series Specifications download pdf (Page 6)

Guided Tour - VR3TD Rear Panel

1: DC input - Connect the supplied 12 volt 250 mA power adapter here, using the strain

relief as shown in the illustration below. WARNING: The substitution of any other kind of

power adapter can cause severe damage to the VR3TD and will void your warranty.

2: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when

connecting the VR3TD to consumer (-10) audio equipment. Wiring is as follows: tip hot,

sleeve ground.

3: Audio Output Level switch - Sets the audio output level attenuation of the balanced

output (see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the “Setting Up

and Using Your VHF TD Series / VHF Series System” section on page 10 in this manual

for more information.

4: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR

jack when connecting the VR3TD to professional (+4) audio equipment. Pin wiring is as

follows: Pin 1 ground (shield), Pin 2 high (hot), and Pin 3 low (cold).

* If required, both the unbalanced and balanced outputs can be used simultaneously.

DC INPUT

UNBALANCED OUTPUT

CAUTION

USE SAMSON

AC ADAPTER

ONLY

AC CABLE LOCK

CABLE LOCK LOOP THRU AND TIE

-10 dB 5KΩ

S. No.

CH :

Diversity Receiver

BALANCED SWITCH

LINE:

-20dBm600Ω

MIC:

-40dBm600Ω

MIC

LINE

BALANCED OUTPUT

XLR:

①GND

②HOT

③COLD

POWER RATING

DC 12V, 1.9W(160mA)

Using the strain relief: Gather up a loop of wire and pass it through the strain relief,

then pass the adapter plug through the loop in order to create a knot.

ENGLISH

1 2 3 4 5 6 7 8 9 10 11 ... 53 54

Comments to this Manuals

No comments

Samson VHF TD Series Specifications Page 6

Comments to this Manuals

Related products and manuals for Microphones Samson VHF TD Series