Samson StudioDock 3i Specifications download pdf (Page 11)

StudioDock 3i and 4i Quick Start

StudioDock 3i and 4i Quick Start - iPod Playback

Your StudioDock system has many sophisticated features, but if you just want to play-

back music from your iPod, you can follow the simple steps below to get started.

• Unpack the StudioDock system components and included cables. Be sure to save

the packaging in case you ever move or need to send the units for service.

• Set the Studiodock monitors in place near your computer or multi media center. The

active speaker (the one with the front panel volume knob and jacks) is the right side

speaker and the passive speaker (no knobs and jacks) is the left speaker.

• Locate the included speaker wire and

make the connection from the active

speaker to the passive speaker. Be sure

to check the color code on the wire to

insure the proper phase (polarity). For

more information, see the sections

" StudioDock 3i and 4i Connections"

on page 8 and "StudioDock 3i and 4i

Wiring Guide" on page 15 in this manu-

al.

• Check that the rear panel POWER

switch is set to the off position. Then,

plug the supplied power cable into the rear panel inlet, but don’t turn the unit on

just yet.

• If your iPod came with a dock adapter (most do) install it into the iPod dock on top

of the active speaker.

• Next, install your iPod into the StudioDock. Be sure the iPod is seated all the way in

and that it's making a good connection in the dock.

• Now power on your StudioDock system using the rear panel POWER switch but

keep the volume down to start.

• Now press play on you favorite iPod tune and adjust the StudioDock’s front panel

volume control until your reach a comfortable listening level.

For more information, see the section " Operating the StudioDock 3i and 4i" on page 12 in

this manual.

iPod

Speaker Cable

ENGLISH

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 87 88

No comments

Samson StudioDock 3i Specifications Page 11