Samson H4 Datasheet download pdf (Page 88)

ZOOM H4

88

Troubleshooting

If there are problems during operation of the H4, check the following points first.

Problems during recording/

playback

◆

No sound, or sound is very weak

• Check the connections to your monitor

system, and the volume setting of the

system.

• Check whether the volume level setting

of tracks 1 – 4 is appropriate.

◆

Recorder stops during playback

• When playback is carried out with a

track in recording standby condition, a

temporary file is created in the H4. If the

remaining capacity of the SD card is

low, the temporary file may use up all

the remaining space, causing playback

to stop. In such a case, cancel the

recording standby condition of the

track.

◆

No sound from connected instrument,

or sound is very weak

• Check input source settings (

→

p. 31,

48).

• Check setting of [INPUT 1 GAIN],

[INPUT 2 GAIN], and [MIC GAIN]

switches (

→

p. 32).

• Check whether recording level setting

is appropriate (

→

p. 31, 48).

• If [INPUT 1]/[INPUT 2] jacks are used,

try raising output level of connected

instrument.

• When the monitor function (

→

p. 51) is

off, the input signal can only be

monitored if a track is set to recording

standby or if the recorder is in the

recording standby condition.

◆

Cannot record on a track

• Verify that [REC] key and key for

recording target track are lit in red.

• If a project is protected, recording is

not possible. Use another project or

turn protection off (

→

p. 58).

• Verify that an SD card is inserted in the

slot.

• Check whether the key-hold function is

enabled (

→

p. 79).

• If the indication "Card Protected" is

shown on the display, the SD card is

write-protected. Slide the write-protect

switch to the non-protected position.

◆

Cannot perform bounce

• Verify that the level of tracks 1 – 4 is not

fully lowered.

• Verify that there is sufficient free space

on the SD card.

Other problems

◆

Cannot use effects

• Check whether effect section is on. The

effect section is off by default in stereo

mode and in 4-track mode.

◆

Cannot use tuner

• Check whether the jack to which the

instrument is connected is selected as

input source.

◆

Unit is not recognized when connected

to a computer via USB

• Check whether the operating system of

the computer meets the requirements

listed on page 80.

• To have the H4 recognized by the

computer, USB mode must first be

selected at the H4 (

→

p. 81).

H4_E.book 88 ページ２００６年９月１日　金曜日　午後７時５６分

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 99 100

Comments to this Manuals

No comments