Samson StudioDock 3i Specifications download pdf (Page 16)

10

Installing the StudioDock on Windows Vista

Installing the StudioDock is a simple

procedure that takes just a few minutes.

Since the StudioDock is USB compliant, you

can use most any PC, connect the included

USB cable and plug and play. You will be

able to control your StudioDock using the

standard audio interface controls in the MAC

or Windows operating system. You will find

detailed instructions on setting up Windows

Vista in the following sections of this manual.

Getting Started with Windows Vista

The StudioDock does not require any

special drivers or software. Just plug in the

StudioDock into a USB port on your computer

and everything is installed automatically.

1. The first time you plug the StudioDock into

a USB port, Windows Vista will install the

universal drivers for that port. A balloon tip

will pop up, telling you it has found the USB

Audio codec (figure 4).

2. When it is finished installing the drivers, it

will say “Your new hardware is installed and

ready to use” (figure 5).

Note: This balloon will not pop up again for

the same USB port.

3. The StudioDock becomes the Default

Device after you plug it in and defaults

to maximum volume. Double-check this

by hovering over the speaker icon in the

bottom right hand corner of the screen. It

should show Volume:100 and "StudioDock"

(figure 6).

4. If it is not the default device, you can set

it under the Sound Properties panel in

Control Panel (figure 7).

5. To set the volume, click the speaker icon

and drag the volume slider (figure 8).

Figure 4

Figure 5

Figure 6

Figure 7

Figure 8

ENGLISH

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

Comments to this Manuals

No comments