Samson AH1/QE User Manual download pdf (Page 10)

1: DC input - Connect the supplied

12 volt 160 mA power adapter here,

using the strain relief as shown in the

illustration below.

WARNING: Do not

substitute any other kind of power

adapter; doing so can cause severe

damage to the UR1 and will void your

warranty.

2: Unbalanced output* - Use this

unbalanced high impedance (5K Ohm)

1/4" jack when connecting the UR1 to

consumer (-10) audio equipment.

Wiring is as follows: tip hot, sleeve

ground.

3: Audio Output Level switch - Sets

the audio output level attenuation of

the balanced output (see #4 below) to

-20 dBm (line level) or -40 dBm

(mic level). See “Setting Up and Using

the AirLine System” on page 16.

4: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack when connecting the UR1 to professional

(+4) audio equipment. Pin wiring is as follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).

* If required, both the unbalanced and balanced outputs can be used simultaneously.

Samson AirLine

Guided Tour - UR1 Receiver / Rear Panel

ENGLISH

UNBALANCED

OUTPUT

BALANCED SWITCH

BALANCED OUTPUT

XLR:

1 GND

2 HOT

3 COLD

LINE:

-20dBm600Ω

MIC:

-40dBm600Ω

MIC

LINE

POWER RATING

DC 12V, 1.9W(160mA)

-10dB 5KΩ

DC INPUT

AC CABLE LOCK

CAUTION:

USE SAMSON

AC ADAPTOR

ONLY

CABLE LOCK: LOOP THRU AND TIE

Using the strain relief: Gather up a loop of wire and pass it through the strain relief,

then pass the adapter plug through the loop in order to create a knot.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 79 80

Comments to this Manuals

No comments

Samson AH1/QE User Manual Page 10

Comments to this Manuals

Related products and manuals for Headphones Samson AH1/QE