Samson AH1/QE User Manual download pdf (Page 7)

6: Unbalanced output* - Use this unbalanced high impedance

(5 - 10 K Ohm) 1/4" jack when connecting the AR1 to consumer

(-10) audio equipment. Wiring is as follows: tip hot, sleeve ground.

7: Balanced output* - Use this electronically balanced low

impedance (600 - 2500 Ohm) XLR jack when connecting the AR1

to professional (+4) audio equipment. Pin wiring is as follows:

Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).

8: Mute (squelch) control -

This control determines the

maximum range of the AR1

before audio signal dropout.

Although it can be adjusted

using the supplied plastic

screwdriver, it should

normally be left at its factory setting. See the “Setting Up and Using Your AirLine System”

section on page 16 in this manual for more information.

9: DC input - Connect the supplied 12 volt 200 mA power adapter here.

WARNING: Do not substitute any other kind of power adapter; doing so can cause

severe damage to the AR1 and will void your warranty.

As shown in the illustration on the left, the supplied AR1 receiver holder can be used to

wall-mount the AR1 in fixed installations.

* If required, both the balanced and unbalanced outputs can be used simultaneously.

Samson AirLine

Guided Tour - AR1 Receiver

Wall-mount AR1 receiver holder

ENGLISH

1 2 3 4 5 6 7 8 9 10 11 12 ... 79 80

No comments

Samson AH1/QE User Manual Page 7